Journal List > J Adv Prosthodont > v.6(2) > 1054177

TOOLS
Turgut, Bagis, Ayaz, Korkmaz, Ulusoy, and Bagis: Erratum: How will surface treatments affect the translucency of porcelain laminate veneers?
Erratum

The Journal of Advanced Prosthodontics 2014; 6(2): 150.

Published online: 22 April 2014

DOI: https://doi.org/10.4047/jap.2014.6.2.150

Erratum: How will surface treatments affect the translucency of porcelain laminate veneers?

Sedanur Turgut1, Bora Bagis2, Elif Aydogan Ayaz1, Fatih Mehmet Korkmaz1, Kᘱvanç Utku Ulusoy3, Yildirim Hakan Bagis3

1Department of Prosthodontics, Faculty of Dentistry, Karadeniz Technical University, Trabzon, Turkey.

2Department of Prosthodontics, Faculty of Dentistry, Izmir Katip Celebi University, Izmir, Turkey.

3Department of Prosthodontics, Faculty of Dentistry, Suleyman Demirel University, Isparta, Turkey.

4Department of Restorative Dentistry, Faculty of Dentistry, Ankara University, Ankara, Turkey.

© 2014 The Korean Academy of Prosthodontics

(open-access):

This is an Open Access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/by-nc/3.0/) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.
[J Adv Prosthodont 2014;6:8-13]
DOI of original article: 10.4047/jap.2014.6.1.8
The article 'How will surface treatments affect the translucency of porcelain laminate veneers?' authored by Sedanur Turgut, Bora Bagis, Elif Aydogan Ayaz, Fatih Mehmet Korkmaz, Kᘱvanç Utku Ulusoy, and Yildirim Hakan Bagis published in February issue [Vol 6, No 1] of The Journal of Advanced Prosthodontics (2014), has an erratum. The size of Al2O3 particles should be written as 30-µm instead of 50-µm. The Journal of Advanced Prosthodontics apologizes to the readers for this error.
MATERIALS AND METHODS
Group (SB), Sandblasting; Ceramic surfaces were abraded for 20 seconds with 30-µm Al2O3 particles (Cojet; 3M ESPE) with a pressure of 2.8 bar and, a distance of 10 mm, perpendicular to the treated surface, by the same operator.
TOOLS
Similar articles